SteriPulse-XL® Systems
• Model RS-3000C - Benchtop System
• Model RS-3000B - Inline Processing System
with operator control
• Model RS-3000M - Inline Processing System
with PLC control
• Model LM-1000 - Litemark™ Light Monitor
RS-3000C - Bench-top for R&D or Production Batch Processing
Model RS-3000C is a complete benchtop sterilization system with
controller and separate Sterilization Chamber containing a 16"
Lamp Housing and lamp. The controller provides all power to the
Lamp Housing as well as complete operator control of the sterilization
process using front-panel controls. Safety interlocks are provided
to protect the user from exposure from the pulsed UV lamp when the
chamber door is open.
The SteriPulse-XL Sterilization Chamber, with removable
Lamp Housing, is detached from the Controller. Ozone is evacuated
to ensure EPA ozone level compliance in the workplace. Forced air
evacuation is in the range of 1-4 volumes per minute to ensure no
heat buildup within the chamber during sterilization. The Chamber
does not evacuate air borne pathogens nor introduce air borne pathogens
into the Chamber while the system is in the ON cycle. The Chamber
has an interlocking door for lockout during the sterilization ON
cycle. The door interlock switch is connected with the safety interlock
switches in the Controller. The Chamber and insert are made of stainless
steel construction for ease of sterilization and disinfection.
Top
of Page
RS-3000B - Continuous Manufacturing with Operator
Controls
Model RS-3000B is a basic sterilization system offering a controller
and a standalone 16" (40.6 cm) Lamp Housing with lamp. The
Controller provides all power to the Lamp Housing as well as complete
operator control of the sterilization process using front-panel
controls. The elliptical reflector provides high peak UV for deep
penetration and high speed processing, as well as maximum energy
for dose-dependent sterilization and for timed start-stop-start
processing.
Top
of Page
RS-3000M - Continuous Manufacturing with PLC Control
Model RS-3000M is a modular system designed for ease
of integration into large scale sterilization systems. Units include
a Controller, High Voltage Power Supply Module, and a standalone
Lamp Housing with lamp. System control is via remote Programmable
Control Logic (IPLC). To accommodate larger inline processing requirements,
additional controllers and lamp housings can be placed end-to-end
to effectively increase the linear exposure length in multiples
of 16-inches (40.6 cm). The elliptical reflector provides high peak
UV for deep penetration and high speed processing, as well as maximum
energy for dose-dependent sterilization and for timed start-stop-start
processing
Top
of Page
LM-1000 - Light Monitor
A useful accessory item that can be supplied with
the SteriPulse-XL® systems is the LiteMark Light Monitor. The
LiteMark Monitoring System is a photo-electric detector module which
is factory supplied mounted on a Lamp Housing (shown on 16"
Lamp Housing below) or Sterilization Chamber to enable the operator
to monitor, on a real-time basis, the performance of a lamp system
during its operating life. Such a capability allows the lamp to
be changed before the output falls below a predetermined safe minimum.
It does this by sensing the light intensity from each flash which
is scattered sideways in the Lamp Housing window and relating it
to the side-scattered intensity produced by the same lamp when new.
Top of Page
|
